Wlan Settings For Phoenix - Nokia RM-609 Service Manual

RM-609
BB Troubleshooting and Manual Tuning Guide

WLAN settings for Phoenix

Use the following to test WLAN using Phoenix:
1 Set phone into Local Mode .
2 From the File menu, select Scan Product and check that the correct product version is displayed
3 From the Testing menu, select Self Test. This opens up a Self Test dialogue box, as shown below.
Select the ST_WLAN_TEST check box as shown and then select Start button. The test turns on the WLAN, sets
up the SPI interface and then downloads the WLAN firmware into the WLAN module. During the download
the WLAN acknowledges the data blocks and so the self test is a good way to confirm that the WLAN module
is communicating with the Host. The result column will change to Passed after a few seconds if operating
properly.
In addition, a test of the Bluetooth interface can be done by selecting the ST_BT_WAKEUP_TEST. This test
verifies the interface to Bluetooth.
Issue 1 COMPANY CONFIDENTIAL Page 3 – 53
Copyright © 2011 Nokia. All rights reserved.