Troubleshooting - LawnMaster GT1018S Operator's Manual

OPERATION
Disposal And Protection Of The Environment
NOTE: Dispose of the trimmer, its accessories and the packaging in an environment friendly manner.
Electrical grass trimmers must not be disposed of with the domestic waste Hand in a redundant trimmer to
a recycling centre. The plastic and metals can then be sorted out and graded for recycling.
Our Service Centre will be happy to answer any questions in this respect. Defective units returned to us will
be disposed of for free.
Replacing Trimmer Spool - part # RS0202
To replace trimmer spool - using index finger and thumb firmly squeeze the two serrated tabs found on
trimmer spool head as shown. Enough pressure will release the spool cover exposing the trimmer spool.
Remover the spool cover and remove the empty spool.
At this time the spool can either be re-filled using 0.065" trimmer line or a replcement spool (part #RS0202)
can be installed. To install new spool, simply place
new spool in spool head knob side facing up and
feed the loose end of the trimmer line through the
round steel eyelet on spool head. The line should
be free. Align the spool cover and snap into place.
Follow the advancing line procedures in earlier
section of this manual.
TROUBLE SHOOTING
Problem
Product does not reach
full power
Trimmer Does Not Start
Unsatisfactory result
Possible Cause
Extension cord not suitable
for operation with this product
Power source (e.g. generator)
has too low voltage
Air vents are blocked
No Main Power
On/off Switch Defective
Worn Carbon Brushes
Motor line
Trimming line worn
15
Remedy
Use a proper extension cord
Connect to another power source
Clean the air vents
Check Power Cord and Plug
Repair By After-sales Service
Advance additional line OR
Replace spool with new trimmer line
Advance additional line OR
Replace with new trimmer spool