Polaris UTV Series 10 2x4 Owner's Manual page 70

MAINTENANCE AND LUBRICATION
Cooling System
Coolant Level Inspection
NOTE: Check the coolant
level when the engine is cold
(room or atmospheric
temperature).
1. Situate the vehicle on
level ground.
2. Check the coolant level
by looking at the
overflow bottle located in
front of the right front
wheel. The coolant level
should be between the
minimum mark (1) and
the maximum mark (2).
3. If the amount of coolant
is not within the operating
range, lift the hood and locate the overflow bottle lid. Remove the
lid and use a funnel to add coolant through the filler opening until
the fluid level has reached the maximum mark. Reinstall the cap.
NOTE: Polaris recommends the use of Polaris Premium 60/40
anti-freeze/coolant or a 50/50 mixture of high quality aluminum
compatible anti-freeze/coolant and distilled water. NOTE: Polaris
Premium 60/40 is already premixed and ready to use. Do not dilute
with water.
NOTE: Always follow the manufacturer's mixing recommendations
for the freeze protection required in your area.
NOTE: In an emergency you can add water alone to the overflow
bottle, but it must be returned to the correct mixture ratio by adding
antifreeze concentrate as soon as possible.
If coolant must be added often, or if the overflow bottle runs
completely dry, there may be a leak in the system. Have the
cooling system inspected by your Polaris UTV dealer.
68
CAUTION
2
1