Turntable Operation; Adjusting The Speed; Turntable Maintenance - Crosley C100 Instructions For Use Manual

TURNTABLE OPERATION

1 Turn the On/Off Switch clockwise to turn on the power, the speed indicator light, which is located
beneath the On/Off switch, will light up.
2 Place a record on the slip mat. When playing a 45-rpm record with a large center hole, place the 45-
rpm adapter on the center spindle.
3 Set the speed to match the record.
4 Remove the stylus protector from the stylus, and release the lock clip from the Tonearm Rest.
5 Set the cueing lever to the up position.
6 Press the Start/Stop Button, the turntable platter will start to rotate.
7 Move the tonearm over the desired groove.
8 Set the cueing lever to the down position, the tonearm will descend slowly onto the record and begin
playing.
9 When play is finished, raise the cueing lever, move the tonearm onto the Tonearm clamp.
10 Press the Start/Stop Button to stop the platter from rotating. Turn the On/Off Switch counterclockwise to
turn off the power.

ADJUSTING THE SPEED

- As long as the pitch control is in center "detent" click position, the turntable is operated at selected speed.
- The speed can be increased or decreased by 10% by the pitch control.
- When the speed is correct for the setting, the strobe dots will appear to stand still while the turntable is
spinning. If the speed is too fast, the dots will appear to move clockwise. IF the speed is too slow, the dots
will counter-clockwise.

TURNTABLE MAINTENANCE

1 Clean the stylus periodically with a soft brush to get rid of the dust.
2 When playback sound becomes distorted or noisy, check the stylus. If the stylus is worn out, replace it
with a new one.
3 Clean the turntable lid and turntable cabinet a soft microfiber cloth periodically to keep the turntable
clean.
4 Use water to aid the cleaning process if necessary. Do not use cleanser that contains alcohol, benzine
etc. which might damage the paint and finish of the turntable.
6