Printer Settings (For Key Operator) - Panasonic DP-8020E Operating Instructions Manual

The following Parameter Settings require the input of the Key Operator Password:

■ Printer Settings (For Key Operator)

No.
00
01
02
03
04
05
06
07
08
09
10
11
12
∗
1 Available only when the optional Multi Page Description Language Controller Module is installed.
∗
2 Available only when the optional Printer Controller Module is installed.
∗
3 Available only when the optional Hard Disk Drive Unit is installed.
60
Downloaded From ManualsPrinter.com Manuals
Function
Modes
PRINTER SETTINGS
COMPLETION TIME
PAGE PROTECTION
ERROR PAGE PRINT
SPOOL FUNCTION
TEXT PRINT
PS CONFIGURATION ∗
1
FONT LIST PRINT (PCL) ∗
2
FONT LIST PRINT (PS) ∗
1
MAILBOX DATA HOLD ∗
3
DELETE MAILBOX ∗
3
PRINT QUEUE DEL
APPLETALK ZONE ∗
1
Function
Prints the printer settings.
PRESS SET TO PRINT
Sets the job completion time setting.
1-999SEC
Selects whether to enable automatic
compression when the received data exceeds
the page memory capacity.
(This is accomplished by reducing resolution,
and/or deleting pixels to fit the data onto the
available page memory, then print it out.)
When the setting is in the "OFF" position, upon
exceeding the page memory capacity, the print
job is deleted and an Error message is displayed.
1:OFF / 2:ON
Selects whether to print the error page.
1:OFF / 2:ON
Selects whether to enable the spool function.
1:OFF / 2:ON
Selects whether to print the text page only.
1:OFF / 2:ON
Prints the PS configuration page.
PRESS SET TO PRINT
Prints the PCL font list.
PRESS SET TO PRINT
Prints the PS font list.
PRESS SET TO PRINT
Selects the automatic holding time frame for the 7 DAYS
mailbox data.
Infinity / 1 DAY / 2 DAYS / 3 DAYS / 4 DAYS /
5 DAYS / 6 DAYS / 7 DAYS
Selects whether to delete All the mailbox data or
only the data Before the time frame selected in
the "09 Mailbox Data Hold" setting.
1:ALL / 2:BEFORE
Selects whether to disable the Key Operator's
Password (authorization) requirement to delete
the print queue.
1:FREE / 2:KEY OP. (Operator)
Inputs a AppleTalk zone name.
Initial
Setting
180SEC
1:OFF
2:ON
2:ON
2:ON
2:KEY OP.