Kärcher NT 35/1 Tact Te M Manual page 19

 Connect the suction hose and insert the
suction nozzle or connect to the dust-
generating device depending on the op-
erating mode.
Warning
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
Horn
The horn blows when the air speed falls be-
low 20 m/s.
Note: The horn reacts to negative pressure.
 Set the rotary switch to the correct suc-
tion hose cross-section.
Anti-static system
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.
Dry vacuum cleaning
The device is fitted with a paper filter
–
bag with locking slide, order no. 6.904-
210.0 (5 pcs).
Note: You can use this appliance to take up
all types of dust up to dust class M. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note: The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values greater
than or equal to 0.1 mg/m
Warning
The flat pleated filter must always be in
place while vacuuming.
To suck fine dust, you can also use an
–
additional paper filter bag, a dust dis-
posal bag (special accessory) or a
membrane filter (special accessory).
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
.
3
EN
 Insert the paper filter bag.
 Insert and lock the suction head.
Installing the dust disposal bag
Illustration
Note: The opening of the disposal bag
must be pulled all the way over the ledge of
the suction support.
 Release and remove the suction head.
 Attach the disposal bag (option).
 Pull disposal bag over the container.
 Insert and lock the suction head.
Install membrane filter
Danger
The membrane filter must not be used to
vacuum health-hazardous dusts.
Note: If you work without the paper filter
bag/disposal bag, you must use a mem-
brane filter to protect the suction head.
Illustration
 Release and remove the suction head.
 Pull the membrane filter (option) over
the container edge.
 Insert and lock the suction head.
Wet vacuum cleaning
Danger
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Close the suction connection
Illustration
 Properly insert the connection socket in
the suction connection.
 Push in the connection socket until it
locks into place.
 Turn the suction connection with the
connection socket to the right to close it
tightly.
Note: The accurate fit is ensured by means
of a "bayonet connection".
– 3
19