Swing Operation - Fujitsu AWY14LSACW Operating Manual

SWING OPERATION

Begin air conditioner operation before performing this procedure.
To select SWING Operation
Open the Remote Control Unit lid to perform swing operation
settings.
Press the SWING button (Fig. 5 m).
The SWING Display (Fig. 6 T) will light.
Each time the SWING button is pressed, the swing operation will change in the
following order.
Up/down swing operation
Swing operation stops
To stop SWING Operation
Press the SWING button and select STOP.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
G Up/down swing: Swing operation begins using the
following range according to the current airflow direc-
tion.
Airflow direction is 1–4 (for cooling, dry).
With the upper airflow-direction louver in the
horizontal position, the lower airflow-direction
louver moves (swings) to direct airflow to a wide
area.
Airflow direction is 5–8 (for heating).
With the airflow-direction louvers set for down-
ward or straight down airflow, airflow is directly
mainly at the floor.
En-11
9312556014-En.pm6.5
Left/right swing operation
Up/down/left/right swing operation
11
G Left/right swing: The airflow-direction louvers move
(swing) in the left/right airflow direction.
G Up/down/left/right swing: The airflow-direction louvers
move (swing) in both the up/down and left/right airflow
directions.
G The SWING operation may stop temporarily when the
air conditioner's fan is not operating, or when operating
at very low speeds.
G If the up/down AIR DIRECTION button is pressed during
the up/down swing operation, the up/down swing
operation will stop and if the left/right AIR DIRECTION
button is pressed during the left/right swing operation,
the left/right swing operation will stop.
2003.6.11, 5:08 PM