Table of Contents
Advertisement
fig. 12
7
Lightly step on the back of the scrubbing head to
release the handle.
WARNING: Never stand on the Shark
Floor Cleaner.
8
Begin cleaning by pressing the Spray Button to
apply the cleaning solution to the carpet that is to be
cleaned. (Fig. 12) Spray the solution continuously
while pushing the unit forward and then pulling it
backward until the area to be cleaned is damp.
NOTE: The first time that you use the Shark
Duo
Floor Cleaner there may be air in the system
™
causing a delay for the solution to come out of the
spray nozzle. Hold the spray button down for 5 to 10
seconds until you see the solution spray out.
9
Using the same back and forth motion, continue to go
over the area a few times without spray. Work your way
through the room or area being cleaned methodically.
Repeat as necessary until the entire carpeted area has
been cleaned. No rinsing is required.
10
If the Reusable Bottle is empty, you can refill it at
any time as long as the Shark
Cleaner is unplugged from the outlet.
11
Once finished, step on the tag of the Carpet/
Rug Cleaning Pad and lift the unit to remove the
Carpet/Rug Cleaning Pad from the Shark
Duo
Floor Cleaner (Fig. 13). Let the carpet dry
™
thoroughly and then vacuum.
fig. 13
Sonic Duo
®
Sonic
®
Sonic Duo
Floor
®
™
Sonic
®
fig. 14
fig. 16
HIGH TRAFFIC AREA CLEANING
Step 1:
™
1
Vacuum your carpets and/or area rugs to remove
any loose dirt, dust, or debris that may have
accumulated in your carpet.
2
Spray the Activating Pretreater Carpet Stain & Odour
Remover to pretreat the area. Spray the area until
saturated and let sit for 5-10 minutes.
Step 2:
3
Attach the Carpet Scrub'n Stain
of the Shark
®
pad has a "Purple" Trim and tag that says Carpet
Scrub 'n Stain
™
(Fig. 14) – the tag should be positioned toward the
back of the Shark
4
Remove the Reusable Bottle by holding it and
pulling up. (Fig. 15) Remove the cap by turning it
counterclockwise.
5
Fill the Reusable Bottle with the "Purple" Trim and
label with water until the "1:3 Water" fill line and then
with the Low Moisture –No Rinse- Carpet Cleaner
until the "Solution" fill line. (Fig. 16) Always fill with
water first and then add the cleaning solution so to
avoid foaming and ensure accuracy when measuring.
fig. 15
Pad to the bottom
™
Sonic Duo
Floor Cleaner. This
™
Pad . Attach the pad as shown in
Sonic Duo
Floor Cleaner.
®
™
5
Advertisement
Table of Contents
