Polishing Your Hard Floors - Shark KD450SL Owner's Manual

Using Your Sonic Duo
IMPORTANT: NEVER add the Wood & Hard Floor
Polish to the Reusable Bottle or run it through the
Shark Sonic Duo
® ™
fig. 30

Polishing Your Hard Floors:

1
Vacuum the floor to remove all loose dirt, dust
and grit from the floor surface. For best results,
we recommend that you clean the floor using the
Shark
® Wood & Hard Floor Cleaner first and allow
time to dry before polishing.
2
Attach the Hard Floor Polishing Pad to the bottom of
the Shark Sonic Duo
®
has an "Orange" trim and the "Orange" tag says
"Hard Floor Polishing Pad". (Fig. 30)
3
Lightly step on the back of the scrubbing head to
release the handle.
WARNING: Never stand on the Shark
Floor Cleaner.
4
Carefully, squirt a liberal amount of the Floor Polish
onto an area of the floor to be polished and place the
polishing pad over it before you start the unit. Make
sure that the polishing pad is saturated and then
squirt the polish in 12 x 12 cm sections. (Fig. 31)
5
Turn the On/Off button to "On (I Low)" setting.
Always squirt the floor polish from a height of 15 cm
above the floor to avoid splashing the polish over the
floor. One bottle is enough to cover 40 m
NOTE: The 500 ml polish bottle is enough to cover
24 m .
2
10
Floor Cleaner - cont.
™
Floor Cleaner unit.
fig. 31
Floor Cleaner. This pad
™
Sonic Duo
®
. (Fig. 32)
2
fig. 32
6
Use the Shark
spread the polish evenly over the floor. Do not go
over an applied area too frequently. Always leave
an area looking wet. If a section begins to look dry
while polishing, add more Wood & Hard Floor Polish
to the area. Repeat until the whole area has been
polished.
7
When going from section to section, do not lift the
Shark Sonic Duo
®
always slide it to the next section. No rinsing is
™
required.
8
Allow the Wood & Hard Floor Polish to dry for at
least 1 hour in light traffic areas and a complete 24
hours for the polish to cure before returning to heavy
traffic areas.
9
When finished, turn the unit off and slide and lift the
Shark Sonic Duo
®
from the area that was just polished. Lay the Shark
Sonic Duo Floor Cleaner on its side and remove
™
the Hard Floor Polishing Pad by hand. (Fig. 33)
NOTE: Depending on the amount of traffic your
floors sustain, Shark
2 months. Touch up high traffic areas as needed
in-between full floor polishes.
fig. 33
Sonic Duo Floor Cleaner to
® ™
Floor Cleaner to move it,
™
Floor Cleaner to remove it
™
recommends polishing every
®
®