High Traffic Area Cleaning - Shark SONIC DUO Owner's Manual

fig. 13
fig. 15
NOTE: The first time that you use the Sonic
Duo there may be air in the system causing a
™
delay for the solution to come out of the spray
nozzle. Hold the spray button down for 5 to 10
seconds until you see the solution spray out.
9 Using the same back and forth motion, continue
go over the area a few times without spray.
Work your way through the room or area being
cleaned methodically. Repeat as necessary until
the entire carpeted area has been cleaned. No
rinsing is required.
10 If the Reusable Bottle is empty, you can refill
it at any time as long as the Sonic Duo
unplugged from the outlet.
11 Once finished, step on the tag of the Carpet/
Rug Cleaning Pad and lift the unit to remove the
Carpet/Rug Cleaning Pad from the Sonic Duo
(Fig. 13). Let the carpet dry thoroughly and
then vacuum.
Visit www.sharkclean.com for other great
quick cleaning products to complement your
Sonic Duo , such as the Shark
™
vacuums.
fig. 14
fig. 16
is
™
Rotator
® ™

HIGH TRAFFIC AREA CLEANING

Step 1:
1 Vacuum your carpets and/or area rugs to remove
any loose dirt, dust, or debris that may have
accumulated in your carpet.
Step 2:
2 Liberally spray the Activating Pretreater Carpet
Stain & Odor Remover to pretreat the area. Spray
the entire area until saturated and let sit for 3-5
minutes.
3 Attach the Carpet Scrub 'n Stain
to the bottom of the Sonic Duo
has a "Purple" trim and tag that is labelled
Carpet Scrub 'n Stain
pad as shown in (Fig. 14) – the tag should be
positioned toward the back of the Sonic Duo
4 Go over the Pretreated High Traffic Area with
the Sonic Duo
Stain Pad using a forward then back motion.
™
Continue to go over the area until most of the
Pretreater has been absorbed by the Carpet
Scrub 'n Stain
but not wet.
Step 3:
5 Attach the Carpet/Rug Cleaning Pad to
the bottom of the Sonic Duo
"Purple" trim and tag that is labelled Carpet/
Rug Cleaning Pad. Attach the pad as shown
in (Fig. 14) – the tag should be positioned
toward the back of the Sonic Duo
6 Remove the Reusable Bottle by holding it and
pulling up. (Fig. 15) Remove the cap by turning
it counterclockwise.
7 Fill the Reusable Bottle with the "Purple" cap
™
and label with water until the "1:3 Water" fill
line and then with the Low Moisture –No Rinse-
Carpet Cleaner until the "Solution" fill line.
(Fig. 16)
Always fill with water first and then add
the cleaning solution so avoid foaming and
ensure accuracy when measuring.
Pad
™
. This pad
™
Pad. Attach the
™
and the Carpet Scrub 'n
™
Pad. The area will be damp,
™
. This pad has a
™
.
™
www.sharksonicduo.com
.
™
5