High Traffic Area Cleaning - Shark SONIC DUO KD450RW Owner's Manual

Carpet, wood & hard floor cleaner
Table of Contents

Advertisement

fig. 12
NOTE: The first time that you use the Sonic Duo
there may be air in the system causing a delay for
the solution to come out of the spray nozzle. Hold
the spray button down for 5 to 10 seconds until you
see the solution spray out.
7
Using the same back and forth motion, continue
go over the area a few times without spray. Work
your way through the room or area being cleaned
methodically. Repeat as necessary until the entire
carpeted area has been cleaned. No rinsing
is required.
8
If the Carpet Cleaner is empty, you can replace it
with a new bottle at any time as long as the Sonic
Duo
®
is unplugged from the outlet.
9
Once finished, step on the tag of the Carpet/Rug
Cleaning Pad and lift the unit to remove the Carpet/
Rug Cleaning Pad from the Sonic Duo
Let the carpet dry thoroughly and then vacuum.
Visit www.sharkclean.com for other great quick
cleaning products to complement your Sonic Duo
such as the Shark
®
. (Fig. 12)
®
Rotator
vacuums.
®
fig. 13

HIGH TRAFFIC AREA CLEANING

Step 1:
1
Vacuum your carpets and/or area rugs to remove
any loose dirt, dust, or debris that may have
accumulated in your carpet.
Step 2:
2
Twist the quick cord release holder to unwrap
the power cord completely. (Fig 9) Plug into an
electrical outlet and slide the "ON/OFF" button to
turn the Sonic Duo
Mode (II). (Fig 10)
®
3
Lightly step on the back of the scrubbing head to
release the handle.
4
Liberally spray the Carpet Pretreater to pretreat the
area. Spray the entire area until saturated and let sit
for 3-5 minutes.
5
Attach the Carpet Scrub 'n Stain
of the Sonic Duo®. This pad has a "Blue" trim and
tag that labelled Carpet Scrub 'n Stain
the pad as shown in (Fig. 13) – the tag should be
positioned toward the back of the Sonic Duo®.
6
Go over the Pretreated High Traffic Area with the
Sonic Duo
®
using a forward then back motion. Continue to go
over the area until most of the Pretreater has been
absorbed by the Carpet Scrub 'n Stain
area will be damp, but not wet.
Step 3:
7
Attach the Carpet/Rug Cleaning Pad to the bottom
,
®
of the Sonic Duo®. This pad has a "Purple" trim
and tag that is labelled Carpet/Rug Cleaning Pad.
Attach the pad as shown in (Fig. 7) – the tag should
be positioned toward the back of the Sonic Duo
on. Select the faster Carpet
®
Pad to the bottom
®
and the Carpet Scrub 'n Stain
www.sharksonicduo.com
Pad. Attach
®
Pad
®
Pad. The
®
.
®
5

Advertisement

Table of Contents
loading

Table of Contents