Vvhpeo\ Ri Wkh Ghylfh - Olsberg Orayonne plus Instruction Manual

Attention: Observe the minimum distances! Use the
prescribed mounting holes!
‡ Drill holes with a diameter of 8 mm for the delivered
dowels (approx. 50 mm deep).
Attention: The included screws and dowels are suita-
ble for mounting on cement, brick or similar walls made
of stone with a dense pattern. They are not ideal for
hollow walls or lightweight concrete walls. If appliances
must be mounted to walls for which the included mount-
ing elements are not ideal, it must be made sure that
corresponding mounting elements are used. The screw
head may be a maximum of 8 mm high.
‡ Pre-assemble wall holder with the accompanying
screws 6 x 40 and washers D=6.4, orientate with level
and screw tightly.

$VVHPEO\ RI WKH GHYLFH

Model 15/335, 15/336, 15/337:
Place the appliance in the exposed latches on the bot-
WRP RI WKH ZDOO KROGHU VHH ¿J   :KHQ SUHVVLQJ DERYH
the retaining brackets lift and continue to press until the
latches on the top left and right lock into the designated
cavities on the back wall.
Model 15/338:
Place the appliance in the exposed latches on the bot-
WRP RI WKH ZDOO KROGHU VHH ¿J   +DQJ WKH ODVW FKDLQ
link of both chains horizontally in the "cross slot" on the
back wall. Press the device until the latches on the top
left and right are locked into the designated cavities on
the back wall.
For all Models:
Attention: If the latches are bent while removing the
wall holder, these must be leveled correspondingly so
that they lock when pressed into the back wall.
After locking, the appliance should be connected with
the wall holder. Check to see if the appliance has been
slightly pulled forward.
latch
retaining bracket
exposed latch
¿J  :DOO KROGHU
,Q ¿J D DQG E WKH JODVV SDQHO KDV D GRW-
ted line so that the minimum distances from
this manual, or if greater, the additional dis-
tances are still to be added.
53,50
¿J D 0RGHO   
54
¿J E 0RGHO 
145,50
400 146
600
21