Construction; Minimum Distances; Assembly Of The Wall Holder - Olsberg Orayonne plus Instruction Manual

Construction

In order to optimally use the heat radiation effect, the
appliance should be installed as close the people re-
ceiving the heat as possible. The farther you are from
the device surface, the less the heat can be felt. Dis-
tances of approx. 1-3m are ideal.
7KH JODVV UDGLDWLRQ FRQYHFWRUV IXO¿OO WKH SURWHFWLYH W\SH
IP24. This means that these appliances can also be
LQVWDOOHG LQ EDWKURRPV LQ WKH ]RQH  VHH ¿J   )XU-
thermore, the installer must execute the building-side
connection in the protective type IP24.
ne ne
1 2
ne
0
ne 1
a) Si e ie
¿J 
When assembling the appliance, an adequate bearing
capacity of the wall must be observed, corresponding
construction guidelines must be considered. In the case
of doubt, contact a building expert.
The heater may not be installed directly below a wall
outlet.
The glass panel consists of single-pane safety glass
(ESG). In contrast to conventional glass, this is consid-
HUDEO\ PRUH UHVLVWDQW DQG LV GHVLJQHG IRU VLJQL¿FDQWO\
higher powers of impact. Nevertheless, you should
avoid excess strains. In the case of damage, ESG will
break into many small parts with dull edges so that the
risk of injury is minimized.
Attention: All types of stress on the glass panel, wheth-
er by leaning of people or objects against it or other acts
of power, must be avoided!
Warning: The glass radiation convector may not be
used if the glass panel is damaged.
20

Minimum distances

7KH IROORZLQJ PLQLPXP GLVWDQFHV WR IXUQLWXUH DQG ÀDP-
mable objects must be complied with due to safety rea-
sons:
‡ upwards
‡ on the side .......................................................... 2 cm
‡ below ................................................................ 10 cm
‡ in front............................................................... 50 cm
To the back wall, there is a distance of 14 mm through
the wall holder.
Dimensi ns in cm

Assembly of the wall holder

The wall holder is installed on the appliance before de-
livery. In order to install on the wall, the wall holder must
ne ne
1 2
be removed from the glass radiation convector.
To do this, loosen the locked latches by pressing on
ne
0
WKH OHIW DQG ULJKW RI WKH VLGH ORFNV ZLWK \RXU ¿QJHUV VHH
¿J  DQG VLPXOWDQHRXVO\ UHPRYH IURP WKH DSSOLDQFH
By model 15/338, remove the safety chains from the
"cross slits".
Remove the wall holder on the appliance bottom from
b) ie
the appliance.
Assembly order:
‡ Orient the wall holder as a gauge on the desired posi-
Model 15/335, 15/336, 15/337....................... 15 cm
Model 15/338................................................. 40 cm
¿J 
tion on the wall with a level, press and draw the holes
VHH ¿J D DQG E 
Model
15/335
15/336
15/337 1000
A B
600 401
800 601
801