Wheels And Tires; Tire Size - Arctic Cat 2008 Prowler Service Manual

Wheels and Tires

KEY:
1. Machine Screw
2. Brake Disc
3. Wheel Hub
4. Hub Stud
5. Cotter Pin

TIRE SIZE

! WARNING
Use only Arctic Cat approved tires when replacing
tires. Failure to do so could result in unstable vehi-
cle operation.
The UTV models are equipped with low-pressure
tubeless tires of the size and type listed in Section 1.
Do not under any circumstances substitute tires of a
different type or size.
! WARNING
Do not mix tire tread patterns. Use the same pattern
type on front and rear. Failure to heed warning could
cause poor handling qualities of the vehicle and
could cause excessive drive train damage not cov-
ered by warranty.
TIRE INFLATION PRESSURE
Front and rear tire inflation pressure should be 0.70
kg/cm² (10 psi).
REMOVING
1. Secure the vehicle on a support stand to elevate the
wheels.
! WARNING
Make sure the vehicle is solidly supported on the
support stand to avoid injury.
2. Remove the nuts securing the wheels; then remove
the wheels.
Back
6. Castle Nut 11. Valve Stem Cap
7. Wheel 12. Wheel
8. Mounting Nut 13. Tire - Rear
9. Tire - Front 14. Wheel Cap
(Prowler)
10. Valve Stem
Back to TOC
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean the wheels and hubs with parts-cleaning sol-
vent.
2. Clean the tires with soap and water.
3. Inspect each wheel for cracks, dents, or bends.
4. Inspect each tire for cuts, wear, missing lugs, and
leaks.
INSTALLING
1. Install each wheel on its hub and secure with the
existing hardware.
2. Tighten to 45 ft-lb.
CHECKING/INFLATING
0741-724
1. Using an air pressure gauge, measure the air pres-
sure in each tire. Adjust the air pressure as neces-
sary to meet the recommended inflation pressure.
2. Inspect the tires for damage, wear, or punctures.
Do not operate the vehicle if tire damage exists.
NOTE: If repair is needed, follow the instructions
found on the tire repair kit or remove the wheel and
have it repaired professionally.
NOTE: Be sure all tires are the specified size and
have identical tread pattern.
3. Check the front wheel alignment (toe-in and
toe-out) and adjust as necessary (see Section 8).
4. Test drive the vehicle on a dry, level surface and
note any pulling to the left or right during acceler-
ation, deceleration, and braking.
Back to Section TOC
! WARNING
7
CD005
Next
7-7