Hardware Installation - D-Link DVG-2101SP User Manual

Hide thumbs Also See for DVG-2101SP:

Table of Contents

DVG-2101SP User Manual

Hardware Installation

Connecting the DVG-2101SP Directly to a Modem in Bridge Mode

If your computer connects directly to a DSL or Cable modem and does not connect to a router, follow the

steps below to install your DVG-2101SP.

Note: If your modem only has the one Ethernet port and it is being used by your computer then you will

require a Router/Gateway, please see the next page for details on connecting using a Router/Gateway..

1. Turn off your computer.

2. Disconnect the power to your Cable/DSL modem (unplug or turn off the power switch).

3. Unpack the Ethernet cable (blue) that comes with DVG-2101SP. Attach one end of the Ethernet cable

(blue) provided in this package to a LAN or Ethernet port on your Cable/DSL modem. If there are no

Ethernet ports available on your modem, you should include a Router/Gateway in your network setup

(see diagram on the next page).

4. Attach the other end of the provided Ethernet cable to the WAN port of the DVG-2101SP.

5. Attach one end of the provided phone cable (grey) to a standard analog telephone.

6. Attach the other end of the phone cable to the PHONE port on the rear panel of the DVG-2101SP.

7. Attach one end of the provided phone cable (grey) to a PSTN wall socket.

8. Attach the other end of the phone cable to the LINE port on the rear panel of the DVG-2101SP.

9. Reconnect the power to the Cable/DSL modem (plug in or turn on the power switch).

10. Unpack the 12V DC power adapter that comes with the DVG-2101SP. Connect the power adapter to the

power connecter on the DVG-2101SP.

11. Connect the other end of the power adapter to an available electrical outlet (wall socket or surge

protector).

12. Restart your PC.

Table of Contents