Hardware Installation - D-Link DHP-208AV User Manual

Section 2 - Installation
Power
Plug in the DHP-208AV into an AC wall outlet. Note that it is not recommended to connect the DHP-208AV to a
power strip or UPS.
Note: Power source is confirmed when the Power LED on the DHP-208AV is illuminated.
Connect the Ethernet Cable
Connect the included Ethernet cable to the Ethernet port
located on the DHP-208AV and attach the other end of
the Ethernet cable to your PC or Ethernet device. Network
Connectivity is confirmed when the Ethernet LED on the
DHP-208AV is illuminated.
Power Saving Mode Enabled
When the Ethernet link activity has been down for 5
minutes, the DHP-208AV will automatically go into power
saving mode. The Power LED will blink intermittently.
WARNING! D-Link powerline devices cannot be configured while in
Power Saving Mode.
D-Link DHP-208AV/DHP-209AV User Manual

Hardware Installation

ROOM C
1
DHP-208AV
ROOM A ROOM B
2
DHP-208AV
Internet Router
EXISTING PLC NETWORK
PC
ROOM C
DHP-208AV DHP-208AV
PC
PC
8