Table of Contents
Advertisement
PPPoE
Choose PPPoE (Point-to-Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will
provide you with a username and password.
PPPoE User Name
PPPoE Password
Check Password
PPPoE Service Name
Idle Time Out
Auto Reconnect
MTU
Copyright © 2008 D-Link Australia Pty. Ltd.
Enter the PPPoE user name supplied by your ISP.
Enter the PPPoE password supplied by your ISP.
Retype the password entered in the previous field.
Enter the PPPoE Service Name (if supplied by your ISP).
Set the specific period of time, in minutes, to disconnect from the ISP when no traffic is
passing through. The setting 0 minute means the VoIP adapter will never disconnect
from the ISP.
Check this checkbox to allow the VoIP Adapter to re-establish the connection if it is
terminated by the ISP. However, if the connection is terminated under any other
conditions (i.e. by Idle Timeout or manual disconnect), the VoIP Telephone Adapter will
not re-establish the connection. This box is checked by default.
Enter the MTU (Maximum Transmission Unit) size. MTU is the largest size packet that
can be sent by the device. If the network stack of any packet is larger than the MTU
value, then the packet will be fragmented before the transmission. During the PPP
negotiation, the peer of the PPP connection will indicate its MTU and will accept any
value up to that size.
DVG-2101SP User Manual
Advertisement
Table of Contents
