Jayco 2004 Talon ZX Owner's Manual page 41

14. Insert the peg end of the tension rafter into the "eye" end of the twist pole. (Fig 3-31)
15. Insert the peg of the tension rafter into the end hole of the end divider bar. Place the twist
pole, ball end, into the socket mounted on the corner of the ramp.
16. Move the side wall of the screen room between the two cables on the side of ramp door.
17. Repeat steps #13 – 16 on the opposite side of the screen room. (Remember to keep the wall
side on the outside of the center twist pole.)
18. Attach the velcro at the front top end edge of the screen room to the canopy beginning in the
middle and moving to the sides. Adjust any gaps at the corners by pulling the screen room
sides toward the trailer. (Fig. 3-32)
19. Attach the velcro on the screen room sides to the velcro sides of the ramp opening. (Fig.
3-33)
20. Attach the velcro at the bottom edges of the screen room to the ramp. (Fig. 3-34)
Fig. 3-32
21. The door of the screen room may be
unzipped and rolled to the top. Secure it
with the velcro straps. (Fig. 3-33)
22. Adjust the twist poles as necessary so the
bottom edge of the screen room is even with
the edge of the ramp. (Fig. 3-34)
23. As desired, the side curtains may be rolled
up and secured with the tie straps. The side
curtains are larger and require two people to
roll them up. (Fig.3-36)
Fig. 3-36
I
CAUTION: In windy & gusty or stormy conditions, we recommend that you take down the
canopy and screen room. Wind and rain damage are not covered under warranty.
Use Of Your Sport Utility Trailer
Fig. 3-33
Fig. 3-37
Fig. 3-34
Fig. 3-35
31