10. For ease of set up and to balance the canopy, begin with the center twist pole, (has the white
crutch tip with hanging wire tie down on one end). Place the "eye" of the twist pole onto
the pegged end of the tension rafter. Place the peg into the center hole of the end divider bar
in the break of the canopy pocket. Move the twist pole into a vertical position to hold up the
canopy. (Fig 3-26 & Fig 3-27)
Fig. 3-26
11. Place the tension rafter white crutch tip end onto the canopy bag at the top of the ramp door
to the right of center. Move the pole to the left into the center position. (Above the brass
center weep hole). (Fig 3-28)
Fig. 3-28
12. Remove the screen room from the storage
bag and unfold it. As the screen room is
unfolded, make sure that it is on the outside
of the center twist pole installed in step #10
with the screens to the exterior of the unit. (Fig 3-29)
13. Starting with one side, insert the tension rafter into the pocket sewn at the top edge of the
screen room with the peg end first. (Fig 3-30)
Fig. 3-30
30
Fig. 3-27
Fig. 3-29
Fig. 3-31
Talon Owner's Manual