Black & Decker KW800 Manual page 28

ENGLISH
FINE ADJUSTMENT WITH THE TRIPLE DEPTH STOP
different depths in the same material, adjust the three
screws on the triple depth stop accordingly.
FITTING THE EDGE GUIDE
The edge guide is used when making parallel cuts or
when making decorative edges.
in the base of your router. Adjust the guide to give the
desired distance and tighten the two wing screws.
ALTERNATIVE GUIDE METHOD
clamped across the workpiece to act as a guiding edge.
FITTING THE VACUUM ADAPTOR
The vacuum adaptor enables the connection of a vacuum
cleaner to your router to keep the workplace clean.
28
KW800_E ML p24-41
two nuts on top of the adaptor and tighten the screws.
After turning the
FITTING THE TEMPLATE GUIDE
triple depth stop,
fine adjustment is
made with a
screwdriver on
the appropriate
screw. When you
wish to make
several cuts at
router bit extends below the template guide, to cut
the workpiece in the shape of the template. In this
way, a number of workpieces are made accurately to
the same shape.
Insert two screws
provided in the
end holes in the
edge guide and
screw them into
the threaded ends
of the two bars.
Insert the two
bars in the grooves
ELECTRONIC SPEED REGULATION (KW800E)
When it is not
possible to use an
edge guide, (such
as when routing
grooves to
support shelves in
a bookcase end),
use a straight
of burning the workpiece, especially when crosscutting.
piece of wood
USING THE DISTANCE PIECE
Locate the
vacuum adaptor
on the base of
your router. Insert
the two long
screws provided,
from the bottom of
the holes; place
28
Use this guide to
make a cutout
shape from a
template. The
template is
secured over the
workpiece using
double-sided tape
or 'G' clamps. The
To fit the template
guide, secure it to
the base of your
router using the
two long screws
provided.
The electronic
speed switch
permits the
setting of the
optimum speed to
suit the router bit
diameter and the
material of the
workpiece. This
reduces the risk
The distance
piece is used
when trimming
wooden or
laminate vertical
projections.
Attach the
distance piece to
the base using
the screws
provided.
16-01-2001, 13:45