Kärcher B 150 R Manual page 22

Install D cleaning head
 Lift the holder of the cleaning head (see
Chapter "Grey intelligent key/.../clean-
ing head replacement".
 Slide the cleaning head under the appli-
ance so that the hose points toward the
rear.
Only slide the cleaning head halfway
under the appliance.
 Remove the lid of the cleaning head.
 Connect the power cord of the cleaning
head to the appliance (same colours
must meet).
 Replace the lid and lock it.
 Slide the cleaning head halfway under
the appliance.
 Connect the hose couplers on the
cleaning head to the hose on the appli-
ance.
 Insert the tab into the middle of the
cleaning head, between the fork of the
lever.
 Align the holder of the cleaning head so
that the drilled holes in the lever and the
cleaning head match.
22
 Insert the stop pin through the bushings
and swivel the locking plate downward.
 Insert the cylinder pin into the boring of
the drawbar.
 Slide the drawbar with the pin the guide
channel on the cleaning head all the
way to the bottom.
 Insert the locking plate into the guide
channel and lock it in.
 Repeat process on the drawbar on the
opposite side.
 Insert the grey intelligent key.
 Set brush type "Disc".
Install R cleaning head
 Lift the holder of the cleaning head (see
Chapter "Grey intelligent key/.../clean-
ing head replacement".
 Slide the cleaning head under the appli-
ance so that the hose points toward the
rear.
Only slide the cleaning head halfway
under the appliance.
 Unscrew the star handle and remove
the lid.
 Connect the power cord of the cleaning
head to the appliance (same colours
must meet).
 Slide the lid in and screw tight.
 Slide the cleaning head halfway under
the appliance.
8
-
EN
 Connect the hose couplers on the
cleaning head to the hose on the appli-
ance.
 Insert the tab into the middle of the
cleaning head, between the fork of the
lever.
 Align the holder of the cleaning head so
that the drilled holes in the lever and the
cleaning head match.
 Insert the stop pin through the bushings
and swivel the locking plate downward.
 Insert the cylinder pin into the boring of
the drawbar.
 Slide the drawbar with the pin the guide
channel on the cleaning head all the
way to the bottom and lock.
 Repeat process on the drawbar on the
opposite side.
 Insert the grey intelligent key.
 Set brush type "Brush".
Remove D cleaning head
 Press in the locking plate and swivel the
drawbar upward.
The subsequent removal will take place in
the opposite order of the installation.