EBDSPIR-PRM-2CH, EBDSPIR-PRM-2CH-NC
Ceiling PIR presence/absence detector 2 channel
Front features
Mounting Bezel
Back features
Retaining Spring
Channel 1
Connector
Retaining Spring
Product Guide
The EBDSPIR-PRM-2CH PIR (passive infrared) presence
detector provides automatic control of lighting loads with
optional manual control. The detector provides two
independently controlled output channels that can be used
for a variety of applications.
All functionality is fully programmable using an IR handset.
Versions sealed to IP55 when installed flush in a ceiling
available on special order. Standard versions are.
EBDSPIR-PRM-2CH
EBDSPIR-PRM-2CH-NC
PIR Sensor
Detects movement within the unit's detection range,
allowing load control in response to changes in occupancy.
IR Receiver
Receives control and programming commands from an
IR (infrared) handset.
Light Level Sensor
Measures the overall light level in the detection area
Status LEDs
Sensor Lens
which covers...
The LED flashes Red to indicate the following:
PIR Sensor
Walk Test LED active
IR Receiver
Light Level Sensor
Valid setting received
Status LEDs
Channel 1 Connector
Live input and output for Channel 1. Switch input
connection that can be used to manually override the lights
on or off.
Channel 2 Connector
Live input and output for Channel 2. Common Neutral
Channel 2
Connector
connection.
Occupancy of two independent lighting circuits using
a single detector, e.g. for essential and non-essential
supplies.
Occupancy and lux control of one lighting circuit and
just occupancy control of a second circuit, e.g. where
a row of luminaries by a window is lux controlled
whilst inner rows are switched on occupancy only .
Occupancy and lux control of a lighting circuit and just
occupancy control of a ventilation circuit .
Occupancy on both lighting circuits, with separate lux
control on each circuit.
Ceiling PIR presence/absence
detector 2 channel
Ceiling PIR presence/absence
detector 2 channel normally closed
Overview
Features
when movement is detected