Brother PJ-722 Online User's Manual page 41

Using the Printer
4 Form Feed Mode
Specifies how the printer responds to form feed commands received from any source.
Available settings: [No Feed], [Fixed Page], [End of Page], [End of Page Retract]
 No Feed - Paper is not fed at the end of a job. Because additional paper is not ejected at the end of the
document, use this setting when printing on non-perforated roll paper. Make sure to set [Paper Type]
to [Roll].
Fixed Page - Paper is fed at the end of a job to suit the vertical length of the selected page size (for

example: letter, legal, A4, or user-defined size). Select this setting when using cut sheet paper. Make
sure to set [Paper Type] to [Cut Sheet] or [Roll].
 End of Page - Paper is fed until the paper sensor detects a pre-printed end-of-page mark on the paper
or the end of the sheet, or until 14" (355.6 mm) of paper has been fed. Use this setting when [Paper
Type] is set to [Cut Sheet] or [Perforated Roll].
 End of Page Retract - Paper is fed until the paper sensor detects a pre-printed end-of-page mark on
the paper. Then, the paper is fed back to the starting position before the next page is printed. Use this
setting when [Paper Type] is set to [Perforated Roll].
5 Feed Margin
Specifies the feed margin for the last page of the print job. Use this option when [Form Feed Mode] is set
to [No Feed].
Available settings: 0" - 2" (0 mm - 51 mm)
6 Feed Position
Specifies the paper feed position for printing on custom paper.
Available settings: [Center], [Left Alignment]
7 Multiple Page
Prints more than one page on a single sheet of paper.
Available settings: [Normal], [2 in 1], [4 in 1], [9 in 1]
8 Page Order
Specifies the page order when a setting other than [Normal] is specified for [Multiple Page].
9 Border Line
Specifies the border line between pages when a setting other than [Normal] is specified for [Multiple
Page].
Available settings: [Solid], [Dashed], [None]
2
33