Table of Contents
Advertisement
TrainMaster Command operations
Tuning your locomotive's performance
MOMENTUM
TrainMaster Command Control's momentum feature simulates the labored performance of a
locomotive pulling a heavy load. Press L, M, or H (located under the CAB-1 Remote
Controller's removable panel) for light, medium, or heavy momentum. The locomotive's
Command reverse unit remembers this setting until you change it. For quick locomotive
response, choose L.
BRAKING AND BOOSTING
There's more to starting and stopping than just turning the CAB-1 Remote Controller
throttle. Use the BOOST and BRAKE command buttons—they give you incremental control
of speed and are the superior way to handle grades, gradual stops-and-starts, and more. Plus,
using BRAKE in the Command environment gives you a bonus RailSounds sound system
effect—the ultra-realistic sound of squealing brakes.
SOUND QUALITY
To achieve your preferred RailSounds sound system master volume level, we recommend
that you adjust your locomotive volume control knob (see Figure 5 on page 21 for the
location). Turn the knob left or right to reach the desired volume level.
For quick remote-control of volume below the master setting—for example, muting—use
the CAB-1 Remote Controller numeric keypad's volume control. Press AUX1 and then 4 on
the numeric keypad to lower the overall RailSounds sound system output.
HIGH VOLTAGE SETTING
Press SET, and the headlight will flash. Get your locomotive moving to the maximum speed
you want it to run, then press BOOST. Use this to keep your locomotive from derailing at
excessive speeds. Turn off the high voltage setting by pressing SET, then BOOST, holding
each for one second.
STALL
Make your locomotive feel more responsive by setting a "stall," or minimum, voltage. Address
your locomotive by pressing ENG and entering the ID#, then press SET. Use the throttle to get
your locomotive moving at your desired minimum speed, and then press SET again. The
locomotive will stop. The next time you throttle up, the locomotive will start at the speed you
set. The Command reverse unit remembers the stall setting until you change it. To clear the
stall setting, press SET twice, holding it for one second each time.
Note!
These settings will be lost when you assign a new engine ID number.
16
Advertisement
Table of Contents
