Odyssey System Command Operation - Lionel SD-80 Owner's Manual

Odyssey System operations

Odyssey System Command operation

U se your CAB-1 Remote Controller to turn the Odyssey System speed control on or off. The
position of the Odyssey switch (see Figure 1 on page 5) is the Odyssey
System default setting when you power up the locomotive. You may override the
default with the following commands. The override settings will be cleared and the default
settings will be restored when the locomotive is powered down.
When you press 7, you will activate a TowerCom announcement. This has no
Note!
impact on the Odyssey System function.
When you press 9, you will activate the Air Release sound and turn on the smoke
Note!
unit (if it was off). This has no impact on the Odyssey System.
Do not wait longer than two or three seconds between pushing the buttons in each sequence.
If the command is not accepted, repeat the sequence.
The locomotive must not be in motion while enabling or disabling the Odyssey
Note!
System speed control.
Turns off Odyssey System speed control
Turns on Odyssey System speed control
12