How To Replace Brush Roll Belt - Alto 530 Operating Instructions Manual

Retainer Bar
Varilla reten
Corde á piano
Brush Roll
Cepillo Giratorio
Brosse tournante
Fig. 12
Motor Cover
Cubierta del
motor
Couvercle du
moteur
Belt
Banda
Courroie
Fig. 13
Low side of belt
Posicion baja de la
banda
Position basse de la
courroie
Fig. 14
Page -18-
Fan Cover
Cubierta del
ventilador
Couvercle du
ventilateur
Bottom Plate
Tapa Rodillo
Cache rouleau
Motor Nut
Tuerca del
ventilador
É crou du
moteur
High side of belt
Posicion alta de la
banda
Position haute de la
courroie
CLARKE TECHNOLOGY 530 Upright Vacuum Operator's Manual

HOW TO REPLACE BRUSH ROLL BELT

NOTE: Turn off the switch and unplug the electrical
cord before replacing belt. Belt can become hot during
normal use. To prevent injury, avoid touching the belt
and motor nut when it is hot.
CAUTION: Improper installation of the brush roll or
brush roll belt could cause carpet
cleaner damage.
1. Push handle release and lower handle; push the
height setting to th lowest position. Turn the
vacuum cleaner so the underneath side and brush
roll face toward you. (Fig. 12)
2. Remover retainer bar by pushing downward on the
right end, until it unhooks. Release other end.
CAUTION: While pushing one end of retainer bar,
hold the machine down to avoid tilting.
3. Remove bottom plate and fan cover by lifting off from
motor. (Fig. 13)
4. Remove belt from motor nut. Pull brush roll up,
remove belt from brush roll and change with a new
belt.
5. Insert brush roll making sure the tabs on the edge of
bearing support are facing upward. Bristles on
brush roll must form a "V" facing toward you.
6. Twist the belt towards the right and place around
motor nut. The higher end of the belt must be on
the right side, and the lower end on the left side, as
shown in the drawing below (Fig. 14). Rotate brush
to ensure belt is positioned correctly.