Hitachi FP-Z31 Operation Manual page 33

- · �
.. ' .. ..
G)
Lens cable plug
Connect this to the LENS connector on the camera head. Once the plug is pushed into place, it is auto­
matically locked. To disconnect the plug, grasp the body of the plug and pull to release the lock; then pull
free.
@
Return video switch [RET]
The viewfinder pictures are switched to signals which are connected to the AUX connector on the operation
panel or into VTR playback signals only for as long as this switch is kept depressed.
@
Zoom servo leyer [T/W]
This lever is for the servo control of the lens. The zoom speed can be varied continuously by the amount
with which the switch is pressed.
Full range operating time
@
Iris mode selector switch [A/Ml
A: Auto iris adjustment mode using rectified video signal
M: Manual iris adjustment mode
@
Iris monentary switch
Establishes the automatic iris mode only while depressing.
@
Remote zoom connector [REM]
... �.-
This connector is used for servo zoom remote control. By using the ZL-15W (lens cable kit for 15x lens), it
is possible to control the VTR start/stop and return video, in addition to the zoom.
(J)
Zoom selector knob [MANU/SE RVO}
Zoom servo control; controlled by lever
SERVO:
Manual zooming
MANU:
@
VTR control switch*
Th is controls the VTR start/stop. Since it is a momentary switch, it is energized only while it is being
pressed. Every time the switch is pressed, start and stop are controlled alternately.
Approx. 2.5 to 20 sec.
=
@
\.'-
.
.
VTR control
switch [ VTR]
31