Character Display And Operation (Fp-Z3 1 Only) - Hitachi FP-Z31 Operation Manual

( 5 ) Registration adjustment
Connect the picture monitor to the MON OUT connector
to the underscanning mode, allow a registration chart to fill the whole monitor screen and check the regis­
tration. If the centering of the pictures in the center area deviates, remove the left cover, and adjust the R/8
centering controls on the DEF unit, referring to the arrangement of the controls on the side panel. If the
registration deviates due to picture distortion at the corners of the picture or to picture tilt, adjust the DEF
unit. The MON OUT waveforms can be selected by the MONITOR SELECT switch
tration adjustments, select R-G and 8-G as appropriate.
See 6.3.6, with the registration adjustment of the model FP-Z31 camera.
6.3 Character display and operation ( FP-231 only)
6.3.1 Warning displays
When the MONITOR SELECT switch
on the screen (the screen which is normally used) that appears when the camera's power is turned on.
Warning characters, indicating that the detail
connector. Furthermore, when the BAR/CAM switch
th.at the bar signals are being fed out to the CAM OUT connector are superimposed on the signals to
the viewfinder and the MON OUT connector.
DETAIL OFF
BASSON
�
6.3.2 Status displays
When the D ISP/WRITE switch
camera's switches are displayed.
The status of the GAIN mode switch PRESET/AUTO
of the high GAIN switch
®
shown is either BAR or CAM.
: AUTO
WHITE
GAIN : ODB
CAM/BARS : CAM
Title write and read operations
6.3.3
When the D ISP/WRITE switch
PLEASE" appears for about 3 seconds in the viewfinder and MON OUT connector signal. This indicates
that titles can be written on the screen, which is indicated inside the viewfinder by the lighting of the
"W" indicator.
18
@
is set to -G, this has the effect of switching off the detail signals
°
signals are OFF, pre fed 9ut to the viewlfinder and MON OUT
®
The detail signals are switched off when -G has been selected.
This appears when the BAR/CAM switch has been set to BAR.
@
is set once to the top position_ , characters showing the status of the
@
shown is O dB, +9 dB or +18 dB; and the status of.tHe BAR/CAM switch
or PRESET
or +9 dB or +18 dB
or BARS
@
is set again to the top position in the status display mode, "TITLE SET
@
on the camera's rear panel, set the monitor
@
is set at tine BAR position, characters indicating
@
shown is either PRESET or AUTO; the status
�: .....
. _,
and so with regis­
-�
��
,_·;; ... :· ..
(1) (
Rand
In su
"TIT
clean
Wh
* R
is·
(2 ) :
The,
Whe1
vyh�r
The·
CUR
swit�
is PO
A ta
-sequ
Twer
on tr
The
CAI\
(3) I
Once
switc
WAI.
DISP
spacE