Hitachi FP-Z31 Operation Manual page 23

(3) When the object or lighting is not suitable for attaining the white balance, the following display appears:
This blinks This blinks
:,t::!�_;
AUTO WHITE :
:J
OBJECT?
TRY AGAIN
When the object or lighting
is not suitable
{Note)
Care should be taken with colored lighting for effects and with mercury lamps or other special lighting since
they are not suitable for attaining the white balance in general.
(4) The following display appears when the white balance cannot be properly set with insufficient I ight:
This blinks
This blink s
LOW LIGHT :}t;
:/; INCREASE LIGHT LEV.
TRY AGAIN
When there is insufficient I ight
(5) The following display appears when the cameraman has forgotten to set the GAi N mode switch
@
PRESET/AUTO to AUTO:
This blinks
I
, \ SET GAON e,ESET SW
TO AUTO
TRY AGAIN
When the GAi N mode switch
has been set to PRESET
•,.:,
Change the object or I ighting and reset the AUTO WHT /
AUTO B LK switch @to the AUTO WHT position_
'
In cases like this, increase the light or set the GAIN switch
@
to 9 dB or 18 dB and set the AUTO WHT / AUTO B LK
switch@ again to the AUTO WHT position.
In cases like this, set the GAIN mode switch
and set the AUTO WHT/AUTO BLK switch @ to the
AUTO WHT position.
,
'
\.&.
@
to AUTO
21