Hitachi FP-Z31 Operation Manual page 27

._- ,:•
. .•
J-.;
� ' A��-� - � 2 - �· · ; �: : ··-. . :�;;��-. � .. :�, . � .. ; --,� � · � · · � <:,·
i
•. . ,.,.:. : - .. .
(1) The following messages appear when the setting has been made properly:
(2) Examples of displays when the settings have not been made properly:
BAR/CAM switch (9) at "BAR":
When the AUTO CENT/AUTO SETUP switch
setting and auto black balance are set, and the R/G/B channel video levels and the gain control systems of
the R/G/B channels are checked by using the built-in test pulses. It is helpful because the camera checks are
completed while the bar signals
(3) Displays when the settings have been made properly:
· .. ·.,;
- �4
:·4 , < •
This blinks Item being adjusted is shown here
AUTO SETUP.
Display until settings are
completed.
This blinks
'
./
.
AUTO SETUP : \!'J_ G .:
BLK SET : OK
BLK BAL : OK
WHT BAL: NG
Displa X when auto white set­
ting is "NG".
are being transmitted.
_
This blinks
Display until checks are com­
pleted.
AUTO SETUP: COMPLETED
0
BLK SET : OK
BLK BAL : OK
WHT BAL: OK
Display when settings have
been made properly.
T<hese blink �.
�--.
IRIS:-- � �:
:::=:CHECK IRIS OR
CHANNEL BLACK
TRY AGAIN
\.
Display when I ightenters dur­
ing black setting.
@
is set to the AUTO SETUP position, the auto black
is dis-
CHECK : COMPLETED
BLK SET : OK
BLK BAL : OK
R GAIN : OK
G GAIN : OK
B GAIN
: OK
\.
Display when settings have
been made properly.
\.!.
'
25