Regency L540PB Owners And Installation Manual page 21

10. Bundle excess wires and power cord - with the exception of the
wire marked receiver.
Receiver wire requires enough slack to reach the front right of the
unit to be connected to the receiver.
Secure wires with cable ties installed in previous step.
Additionally secure wires with a wire clip to be installed in location
shown below.
Left
Cable Tie
Receiver Wire
11. Install receiver onto backing plate with 2 screws and plug in
receiver cord shown in Step 8.
L540PB-2 / HZI540PB-2 Direct Vent Gas Insert
Right
Wire Clip
Cable Tie
Cable Tie
12. Connect receiver wire from the wiring harness to the back side of
the remote receiver as shown below
13. Bundle excess receiver wire using the 4th cable tie and secure to
the front right of the fi rebox as shown below.
INSTALLATION
21