Connecting The Camera Cables; Attaching The Number Plates; Specifications - Sony HDLA1500 Operation Manual

Note
Some tripods cannot be attached unless the feet and cable
hanger are removed from the adaptor. Remove the feet and
hanger to use such a tripod (see page 38).

Connecting the Camera Cables

You can connect/disconnect cables to/from the camera
mounted in the adaptor without opening the rear panel of
the adaptor.
Pass the cables through the opening below the rear panel.
When you connect cables with the rear panel of the adaptor
open, make sure that the cables are not caught when you
close the rear panel.

Attaching the Number Plates

Insert the projections on the both sides of a number plate
(supplied) into the notches in the holder on the side panel.
The number plate for the up tally can be attached in the
same manner.
Number plate holder
Number plate
2

Specifications

General
Power requirements 240 V AC, 1.2 A (max.)
180 V DC, 0.65 A (max.)
12 V DC, 9 A (max.)
Operating temperature
−20°C to +45°C (−4°F to +113°F)
Storage temperature −20°C to +60°C (−4°F to +140°F)
Mass HDLA1500:
Approx. 18.5 kg (40 lb 13 oz)
HDLA1505:
Approx. 17.1 kg (37 lb 11 oz)
HDLA1507:
Approx. 15.5 kg (34 lb 3 oz)
Input/output connectors
LENS 36-pin (1) (HDLA1500/1505 only)
VF D-sub 25-pin (1) (HDLA1500/1507
only)
DC IN XLR 4-pin (1), 10.5 to 17 V DC
DC OUT 4-pin (1), 10.5 to 17 V DC, 1.5 A
maximum
It may be limited depending on the
load and input conditions.
Supplied accessories
Operation manual (1)
Camera hangers (2) (HDLA1500/1505)
Angle-adjusting plates (2)
Cable clamps (2)
Number plates for side panel (2 sets)
Number plates for up-tally lamp (1 set) (HDLA1500/1505)
Stopper (1) (HDLA1500/1507)
Fixing screw for stopper (1) (HDLA1500/1507)
Optional accessories
HDVF-700A HD Electronic Viewfinder (7-type,
monochrome)
HDVF-9900 HD Electronic Viewfinder (9-type, color)
BKP-7911 Script Holder
45
Specifications