Sony HDLA1500 Operation Manual page 43

3
Turn the viewfinder counterclockwise. Then turn the
panning lock lever counterclockwise to lock the
viewfinder in place.
To adjust the viewfinder position
You can use the viewfinder in any of three positions.
To change the viewfinder position, proceed as follows:
1
Loosen the knob 1 of the handle and push in on the
tab 2 to release the handle.
1
2
Rotate the handle toward the front.
In case of the HDLA1500, push the handle into the
catch on the adaptor.
3
While pulling the release knob 1 on the left side to
release the viewfinder table, slide the table as 2 to an
appropriate position. Then push the lock lever 3
toward the front to lock the viewfinder table in place.
Panning lock
lever
When returning the camera handle to its original
position
Fully return the handle until it locks in place and firmly
tighten the knob of the handle.
2
To remove the viewfinder
1
Release the panning lock lever and turn the viewfinder
90 degrees clockwise from the operation panel of the
adaptor.
You cannot detach the viewfinder from the camera
unless it is in this position.
[1500]
Handle catch
1
3
2
43
Installation