Daikin BRC1E62 Operation Manual page 21

3
Cool
Set to
Cool/Heat Selection Eligibility
• The "Cool", "Heat", "Auto" can be set by only the remote controller that has the cool/heat selection
eligibility.
(The display "Auto" will appear for the Heat Recovery System only.)
The remote controller with
the selection eligibility
1.
(Icon "
(Changeover Under
Control) is not displayed)
The remote controller with
the selection eligibility
2.
(Icon "
(Changeover Under
Control) is not displayed)
4PWEN71265-1A_01_OM_ENGLISH.indb 20
• Press Mode Selector button on the remote
controller that has the cool/heat selection
eligibility (the remote controller without the icon
28
Cool
°C
" ") several times until the desired mode is
selected.
The display will change to "Fan", "Dry", "Auto",
"Cool", "Heat" each time the button is pressed.
• The display "Auto" will appear for the Heat
Recovery system only.
Simultaneously, the other remote controllers will
follow suit and change the display automatically.
Set to "Cool", "Heat",
" "Dry", "Auto" mode.
Set to "Fan" mode.
"
Other remote controllers
(Icon " "
(Changeover Under
Control) is displayed)
• The system will go into the mode set in
the remote controller with the selection
eligibility. Other modes are not
available.
• However, the system can be switched
to "Fan" mode.
In case of "Cool" or "Dry" mode, the
system can be switched to "Dry" mode
from "Cool" mode and to vice-versa.
Other remote controllers
(Icon " "
(Changeover Under
Control) is displayed)
• The system cannot be set to other
modes except fan mode.
20
1/29/2013 6:40:18 PM