Notice Before Installation; Section 2: Installation - Monitor GF3800 Servise Manual

MONITOR HEATING SYSTEM
Section 2: Installation
2-1 NOTICE BEFORE INSTALLATION
The heater must be installed by a qualified service
person according to this installation instruction .
The installation must conform with local codes or,
in the absence of local codes, the National fuel
Gas Code, ANSI Z223.1/NFPA54.
The installation must conform with local codes or,
in the absence of local codes, the current CAN 1 -
B149 INSTALLATION CODE.
For mobile housing and recreational vehicle
installation the current Standard CSA Z 240.4
GAS EQUIPPED RECREATIONAL VEHICLES
AND MOBILE HOUSING.
A manufactured home (mobile home) installation
must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR,
Part 3280, or, when such a standard is not
applicable, the Standard for Manufactured Home
installations, ANSI A 225.1/NFPA 501 A.
Due to high temperatures, the appliance should
be located out of traffic and away from furniture
and draperies.
Children and adults should be alerted to the
hazards of high surface temperatures and should
stay away to avoid bums or clothing ignition.
Young children should be carefully supervised
when they are in the same room as the appliance.
Clothing or other flammable material should not
be placed on or near the appliance.
Make sure that the flow of combustion and
ventilation air is not obstructed.
Any safety or guard removed for servicing an
appliance must be replaced prior to operating the
appliance.
A\ WARNING
Do not operate appliance with the panel removed,
cracked or broken. Replacement of the panel
should be done by a licensed or qualified service
person.
Installation and repair should be done by a
qualified service person. The appliance should be
inspected before use and at least annually by a
qualified service person. More frequent cleaning
may be required due to excessive lint from
carpeting, bedding material, etc. It is imperative
that control compartments, burners and
circulating air passageways of the appliance be
kept clean.
Do not use this heater if any part has been under
water. Immediately call a qualified service
technician to inspect the heater and to replace
any part of the control system and any gas control
which has been under water.
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in
the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70 .
The appliance, when installed, must be electrically
connected and grounded in accordance with local
codes or, in the absence of local codes, with the
current CSA C22.1 CANADIAN ELECTRICAL
CODE.
/^WARNING
THIS APPLIANCE IS EQUIPPED WITH A THREE-
PRONG (GROUNDING) PLUG FOR YOUR
PROTECTION AGAINST SHOCK HAZARD AND
SHOULD BE PLUGGED DIRECTLY INTO A
PROPERLY GROUNDED THREE-PRONG
RECEPTACLE. DO NOT CUT OR REMOVE THE
GROUNDING PRONG FROM THIS PLUG.
ZL WARNING
IN MANUFACTURED/MOBILE HOMES WIRED
FOR 120/240V, ENSURE THAT THE GF3800/GF1800
IS ONLY PLUGGED INTO A 120 VOLT CIRCUIT.
/K CAUTION
Before converting the GF3800/GF1800 gas type
(to Liquid Propane or Nat Gas), Read instructions
in Section 2, Page 21, 22.
For manufactured home (USA only) or mobile
home or residential installation convertible for use
with natural gas and liquefied petroleum gases
when provision is made for the simple conver-
sion from one gas to the other.
13