Monitor GF3800 Servise Manual page 18

MONITOR HEAT1NU bYb I hMb
Section 2: Installation
If the unit is installed so that it is enclosed on both sides
and top, the following instructions shall be carried out.
With the side and top clearances as shown in Fig. 2-1
the Monitor shall not be placed so that its front surface
is inside of the enclosure.
6"min
(15.24cm)
(13.Scm)
Fig.2-1
GF1800
Fig. 2-2
• The heater may be installed on combustible
flooring on the metal tray provided.
NOTE: Use the cardboard template provided with
the Heater for flue pipe location.
Just in case the template was misplaced, the
approximate flue pipe hole location measurements
are as follows:
Back of Heater
opening, which connects
to the Flue Pipe.
The center of the Joint Rpe
opening, which connects
to the Rue Pipe.
Back of Heater
9"
TV,'
10V4-
Fuel Inlet
GF1800
r
Floor
»The wall where flue pipe hole will be cut should
be free of plumbing pipes, electrical wires,
studs, air ducts and other obstacles.
15