Table of Contents
Advertisement
Infoprint 1222
Partial Blank Image/White Spots (no periodic pattern)
FRU
Toner Cartridge (not a FRU)
Fuser Backup Roll Springs
(not a FRU)
Fuser Assembly
Paper
Variation in Image Density Horizontally Across Page
FRU
Toner Cartridge
Transfer (Roll)/Bearings
Transfer Assembly Roll
Action
Remove the toner cartridge and
gently shake the assembly to evenly
distribute the toner.
If the toner cartridge is low, try a new
one.
Check springs at each end of the
backup roller springs and backup
roller to ensure adequate and even
pressure is applied to the fuser hot
roll. Replace the fuser if necessary.
Make sure recommended paper is
being used.
Action
The charge roll in the toner cartridge
may have an unbalanced pressure
against the PC drum.
Try a new toner cartridge.
Check the springs and bearings at
both ends of the transfer roller. The
bearing assemblies should support
the transfer roller, applying even
pressure to the PC drum.
Replace both bearing assemblies if
either spring shows signs of damage
or fatigue.
Inspect the transfer roller for signs of
wear or damage and replace as
necessary.
Diagnostic Information
2-49
Advertisement
Table of Contents
