Table of Contents
Advertisement
Infoprint 1222
Paper Never Picks
FRU
Paper Tray
Paper Feed Solenoid
RIP Card Assembly
2-42
Service Manual
Action
Make sure the paper tray and paper
are correctly positioned.
Check the input tray for missing or
broken parts.
Replace the tray as necessary.
Make sure solenoid is installed
correctly and its cable is plugged into
the RIP card assembly. See
"Locations" on page 5-1
information.
• Verify approximately 40 ohms in
the solenoid. If not correct,
replace the solenoid.
• Verify the solenoid has the spring
in place and functions
mechanically. If this is true and the
resistance is correct, replace the
RIP card assembly.
Always check
Note:
printhead alignment after
replacing the RIP card
assembly. See
Assembly Adjustment" on
page 4-2
for hardware
alignment of the printhead.
for more
"Printhead
Advertisement
Table of Contents
