Table of Contents
Advertisement
Infoprint 1222
7. Unplug the fuser lamp, exit sensor, and thermistor cables [B].
Note: It may be easier to unplug the fuser lamp once the fuser is
loosened.
8. Remove the four screws [A].
Note: Removing the lower left screw requires a long screwdriver
(approximately a 6–inch shank).
9. Remove the fuser.
10. To replace the fuser lamp, remove the two screws at each end
and very carefully extract the lamp from the heater roll.
Warning: Do not touch the glass of a good lamp; it causes
premature failure.
Repair Information
4-19
Advertisement
Table of Contents
