Warnings And Error Messages - Henny Penny OFE-322 Technical Manual

1-4. WARNINGS AND
ERROR MESSAGES
DISPLAY
"W-1"
Incoming supply voltage too low
"LOW
VOLTAGE"
"W-2"
Faulty components or connections
"SLOW
HEAT-UP"
"W-3"
Product loaded into frypot
"WAS NOT
before
READY"
"W-4"
Too much product
"SLOW
in frypot
COOKING"
"W-5
Product loaded into frypot
"SLOW
before
COOKING"
"W-6"
Faulty components or connections
"SLOW
COOKING"
"W-7"
Faulty components or connections
"LOW AMPS"
"W-9"
Product overcooked. (may
"DISCARD appear after a "SLOW COOKING"
PRODUCT"
warning)
"OIL TOO Didn't allow shortening to drop
HOT" to current product's setpoint
temperature
405
The controls monitor procedure problems and system failures
with warnings and error codes. The display shows the
warning or error code, and an alarm sounds.
Pressing
control button stops most error code alarms. But there are
some exceptions (see below). The display shows the error
until the situation is corrected.
WARNINGS
CAUSE
lights
lights
cancels most warnings and pressing any
CORRECTION
Have voltage at plug and receptacle checked
Have elements, connections, and contactors
checked
Wait until shortening is at proper temperature
before loading product
Do not overfill frypot
Wait until shortening is at proper temperature
before loading product
Have elements, connections, and contactors
checked
Have elements, connections, and contactors
checked
Discard product immediately
Cancel button stops this warning; once the
shortening drops to setpoint temperature,
the alarm automatically stops
1-5