Makita 9564CR Technical Information page 6

R
epair
[3]-2 Large Spiral Bevel Gear on Spindle and Ball Bearing 6201DDW (cont.)
DISASSEMBLING
Note: If it is difficult to remove
Ball bearing 6201DDW
in the way shown in Fig. 13,
use Arbor press as illustrated
in Fig. 13A.
ASSEMBLING
Take the disassembling step in reverse.
Note: Be sure to apply adhesive (i.e., ThreeBond 1321B/1342 or Loctite 242) to the threads of M4x16 Hex. socket head
bolts (4pcs.) for securing Bearing box to Gear housing complete when reusing the bolts.
[3] DISASSEMBLY/ASSEMBLY
[3]-3 Shaft Lock Mechanism
DISASSEMBLING
Disassemble Shaft lock mechanism as illustrated in Figs. 14 and 15.
Fig. 14
Pin cap
1R350
Applying 1R268 to Pin through the small hole on Pin cap,
strike 1R268 with Hammer.
Pin comes out from Gear housing complete.
ASSEMBLING
(1) Be sure to use a new Pin cap for replacement and to remove all the plastic dust on Pin. (Fig. 16)
(2) Assemble the components for Shaft lock mechanism as illustrated in Fig. 17.
Fig. 16
Plastic dust
Pin
O ring 6
Fig. 13A
1R268
Pin
Fig. 17
Insert Pin through the hole
of Gear housing complete.
Round bar
for Arbor
Fig. 15
Impossible to reuse Pin cap,
because removal of Pin damages
Pin cap
the inside surface of Pin cap.
Release 1R268 from Pin cap while paying
Attention that the Pin cap would not be
slung by Compression spring 8.
Assemble Pin cap by pressing it to Pin.
Pin
P 6/ 9
Bearing box
Ball bearing
6201DDW
Pin cap
Compression spring 8
Pin cap
Compression spring 8
Be sure to insert
Compression spring 8.