Makita 9564CR Technical Information page 2

R
epair
CAUTION: Unplug the tool and remove the wheel cover and grinding wheel from the machine
for safety before repair/ maintenance in accordance with the instruction manual!
[1] NECESSARY REPAIRING TOOLS
Code No. Description
1R004 Retaining ring pliers ST-2 Removing Retaining ring S-6 from Armature shaft of model 9566CR and 9566CVR
1R041 Vise plate
1R217 Ring 22
1R268 Spring pin extractor 3
1R269 Bearing extractor
1R291 Retaining ring S & R pliers Removing / mounting Retaining ring S-12 from / to the drive end of Armature shaft
1R340 Bearing retainer wrench
1R350 Ring 60
Note: Spiral bevel gears vary in type from model to model. See list shown below.
Model No.
9564CR, 9564CVR, 9565CR,9565CVR
9566CR, 9566CVR
[2] LUBRICATIONS
Apply Makita grease SG No.0 and Disulfied molybdenum to the following portions designated with triangles to protect
parts and product from unusual abrasion.
Item No. Description
3 Gear housing complete Gear room
6 Small spiral bevel gear
7 Lock ring 12
Fig. 1
3
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Armature, Small Spiral Bevel Gear on Armature shaft
DISASSEMBLING
(1) In order to protect Armature's commutator, disconnect carbon brushes from the Commutator as illustrated in Fig. 2.
Fig. 2
First, remove Rear cover by unscrewing
4x18 Tapping screw.
Brush holder
Rear cover
Use with Vise to protect the clamped part
Supporting Bearing box when Removing spindle from Large spiral bevel gear
Removing Pin for Shaft lock
Removing Ball bearing 627DDW from commutator end of Armature
Removing / mounting Bearing retainer
Supporting Gear housing when removing Pin for Shaft lock
Small spiral bevel gear on Armature shaft Large spiral bevel gear on Spindle
Spiral bevel gear 11 (teeth: 11)
Spiral bevel gear 9 (teeth: 12)
Portion to lubricate
Cylindrical portion where armature shaft is inserted
Cylindrical portion which accepts 6 's drum portion
6
Shift Spiral spring from
Carbon brush top.
Use for
Spiral bevel gear 38 (teeth: 38)
Spiral bevel gear 35 (teeth: 35)
Makita grease SG No.0.
Disulfied molybdenum
Armature
7
Disconnect Carbon brush from
commutator by pulling up.
No need to remove.
4x18 Tapping screw
P 2/ 9
Lubricant Amount
15g
a little