INSTRUCTION MANUAL Angle Grinder 9561CR 9561CVR 9562CR 9562CVR 9564CR 9564CVR 9565CR 9565CVR 009415 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 END202-6 For Model 9561CR/CVR,9562CR/CVR ENG102-3 Symbols Noise The following show the symbols used for the equipment.
Distractions can cause Makita Corporation responsible you to lose control. manufacturer declare that the following Makita Electrical safety machine(s): Power tool plugs must match the outlet. Never Designation of Machine: modify the plug in any way. Do not use any...
When operating a power tool outdoors, use an 19. Do not use the power tool if the switch does extension cord suitable for outdoor use. Use of not turn it on and off. Any power tool that cannot a cord suitable for outdoor use reduces the risk of be controlled with the switch is dangerous and electric shock.
Operations such polishing Keep bystanders a safe distance away from recommended to be performed with this power work area. Anyone entering the work area tool. Operations for which the power tool was not must wear personal protective equipment. designed may create a hazard and cause Fragments of workpiece or of a broken accessory may fly away and cause injury beyond immediate personal injury.
resist kickback forces. Always use auxiliary or binding of the wheel in the cut and the possibility handle, if provided, for maximum control over of kickback or wheel breakage. kickback or torque reaction during start-up. The b) Do not position your body in line with and operator can control torque reactions or kickback behind the rotating wheel.
18. Be careful not to damage the spindle, the SAVE THESE INSTRUCTIONS. flange (especially the installing surface) or the lock nut. Damage to these parts could result in wheel breakage. WARNING: 19. Make sure the wheel is not contacting the DO NOT let comfort or familiarity with product workpiece before the switch is turned on.
5. And lower speed is obtained when it is turned in the direction of number 1. For Models 9561CR,9562CR,9564CR,9565CR Refer to the below table for the relationship between the number settings on the dial and the approximate rotating 1.
ASSEMBLY For tool with clamp lever type wheel guard 1. Wheel guard 2. Bearing box CAUTION: 3. Screw Always be sure that the tool is switched off and • 4. Lever unplugged before carrying out any work on the tool. Installing side grip (handle) 002980 1.
1. Lock nut wrench 1. Marking C 2. Shaft lock 007363 005261 To remove the wheel, follow the installation procedure in Place the dust cover attachment so that the side of the reverse. dust cover attachment with the marking (A,B or C) faces towards the tool head.
If you need any assistance for more details regarding During the break-in period with a new wheel, do not work these accessories, ask your local Makita Service Center. the grinder in the B direction or it will cut into the Wheel guard (Wheel cover) •...
Makita Corporation Anjo, Aichi, Japan 884863B226...