Century Radikal G20 Instruction Manual page 7

HEAD ASSEMBLY (HD VERSION)
BAG 1
Pushrod assembly (parts 2 through 4) is already assembled but check that the length is
actually 43mm (center to center). As the pushrods are built and installed they should be
checked for tightness. Press one ball link onto each double studded steel ball, making sure
that pressure is applied from the side of the ball link with circle mark. While holding one fly-
bar control arm, apply a small amount of slow cyanoacrylate glue and thread one end of the
double studded steel ball into each standoff. When it becomes difficult to turn with fingers,
apply slow CA to the threads and start screwing in the tapered control arm stand-off on
the other end of the ball. Slide and center the flybar through the head assembly. Care-
fully look at the flybar control arm assemblies from the previous step and notice
that when installed correctly, the securing set screw is on top. Insert one
M4x6x0.5 micro washer #CNLR1006 against each bearing then slide
the control arm halves onto each side, so that they match togeth-
er and the set screw remains on top. Insert one M3x12 but-
ton head socket screw to secure the opposite standoff.
Hold the tapered standoff using pliers while tight-
ening the screw as the rotor head
rotates clockwise.
8
7
Loosely tighten the M4x5 set screws into the round aluminum inserts aligned with the flat spots on the flybar. Tighten both set screws, one
at a time using Medium threadlock. Make a pencil mark 5mm past the threads on both ends of the flybar. Thread the flybar paddles onto the
flybar until the mark is reached and align the paddles parallel. Again using the ruler, rotate one paddle or the other to get equal distances while
remembering the leading edge of the paddles turn clockwise.
No.
Part #
1 HI3176C
Flybar Arms(
2 HI6145 Ball Link Set( 球头连接头)
Pushrod Set( 拉杆)
3 HW6192
4 HI3176C Flybar Arms(
Flybar Arms(
5 HI3176C
6 CNM3X12BHCS M3x12 Button Head Cap Screws( 圆头螺丝)
7 HI6179B Flybar Paddles( 平衡翼)
HW3173A
8 4mm Flybar 500mm(平衡杆)
CNM4X5SS
9 M4x5 Socket Head Set Screw( 无头内六角螺丝)
CNLR1006
M4X6X0.5 Washer( 平面垫片)
10
9
Description
平衡翼控制臂)
球头双牙螺丝)
平衡翼控制臂)
10
4
3
1
Make sure the distance on
both sides are equal
Qty
2
NOTICE SIZE OF HOLES ON BALL LINKS
2
2
2
2
2
2
1
2
2
Page 7
Radikal Gasser
Apply a small amount of cya-
noacrylate glue to the special
5
All ball links are molded to be in-
stalled in only one direction. Look
carefully at the hole for the ball
as that side is 1mm larger .
2
CNM3X12BHCS
CNM4X5SS
HW3176C
Make sure the distance on
both sides are equal
THE SIDE WITH THE SMALLER HOLE
SHOULD FACE OUTWARDS
6
long thread ball.