Attaching Tail To Main Frame - Century Radikal G20 Instruction Manual

ATTACHING TAIL TO MAIN FRAME

BAG 4
Install the tail assembly onto the main frames by using threadlock on eight
the M3x8 button head cap screws. Make sure to install two screws oppo-
site of each other on either side and tighten down making sure the transmis-
sion gear is properly meshed with the tail drive gear. If you are unsure about
proper gear mesh, use a strip of paper slightly taller than the tail drive gear
and pass it between the gears as you spin the tail drive gear. As the paper
passes through from one side of the frames to the other, a nice zig-zagged
pattern should develop. If it is a very faint zig-zag pattern or no pattern ap-
pears, the gear mesh is too loose. If the paper comes through crushed, the
gear mesh is too tight. After the tail assembly is installed on the main frame,
install the tail boom braces using the two M3x25 cap screws and boom
support posts making sure to apply medium threadlock.
CNM3x8BHCS
3
1
CNM3x25CS
Page 36
2
No.
Part #
CNM3x25CS
1 Cap Screw(杯头内六角螺丝)M3x25
HW6202BS Boom Support Posts( 铝柱 )
2
CNM3x8BHCS Button Head Cap Screw( 圆头内六角螺丝)M3x8
3
Radikal Gasser
Description
Qty
2
2
8