Head Assembly (Lt Version) - Century Radikal G20 Instruction Manual

HEAD ASSEMBLY (LT VERSION)

BAG 1
Do not open all the bags prior to starting assembly. Open the bags step by step as you go through the instruction manual. The
components are bagged to make assembly easier. The next few pages will pertain to the assembly of the head. Please follow
the instructions based on the head type you own. Make sure to apply threadlock to any screws going into metal.
Insert one ball bearing into each bearing cup and insert into
the offset plate. Apply one small drop of slow cyanoacrylate
glue (Slow CA) to the joint between the backside of the
bearing cup and the offset plate. Insert one ball
bearing into each tie bar. Using an available
M3 socket cap screw, form threads
into both ends of the tie
bars. Insert one
5
M3x6 button head
screw through
the right side
hole of the
offset plate 4
and thread
3
into one
tie bar.
2
1
3x5x7.5
CNM3x6BHCS
CNBB37
CNBB48
6
ton head screw through the tie bar
bearing, slide one steel spacer and care-
fully apply Medium threadlock to the exposed
threads and insert into the right side of the head
block. Do not overtighten. Repeat for the second
sub-assembly. Once complete apply a small amount of
slow cyanoacrylate glue and insert one CNLR1020 special
long thread ball into each offset plate to complete the assembly.
CNLR1017 L=6.5MM
CNM3x14BHCS
Take special care when pressing in these bearings. Do not
press in on the inner sleeve of the bearing
7
Make two identical
subassemblies . Note
that the bearing cups
face outwards from the head
block. Insert one M3x14 but-
8
Do not secure all the screws until lining up the
components in the following steps.
No.
Part #
1 CNM3x6BHCS
Button Head Screw( 圆头螺丝)M3x6
CNBB48 Bearing(滚珠轴承)4x8x3
2
CNLR1017 Stainless Ball, 3mm Thread, Medium(M3球头螺丝)
3
4 HI3167B Seesaw Offset Plate(平衡杆控制器)
Bearing(滚珠轴承)3x7x3
5 CNBB0730
6 HI3167G Seesaw Offset Plate 2(平衡杆控制器2)
HI3167S 3x5x7.5 Seesaw Tie Bar Set(铁套)
7
8 CNM3x14BHCS Button Head Screw( 圆头内六角螺丝)M3x14
HI6160A Head Block(主旋翼中心座)
9
Page 6
Radikal Gasser
Description Qty
2
2
2
2
2
2
2
2
1
9