Mounting Main Blades - Century Radikal G20 Instruction Manual

MOUNTING MAIN BLADES

If using wood blades, make sure
the blade roots are glued with a
medium CA or epoxy. Make sure
you're glueing onto the wooden part
of the blade and not directly onto
plastic covering of the blades. If the
plastic covering is in place and con-
tacting the plastic blade roots, make
sure to cut this away prior to glueing.
It is recommended to fly this model with
carbon fiber blades however, when flying
with wooden blades, make sure to keep
the head speed below 1850RPM.
CNM4LOCK
1
2
4
Optional Blades:
CN266001 RotorTech® 600mm Blades
CN266166C RotorTech® 610mm Blades
CN266266C RotorTech® 620mm Wide Cord Blades
CN266466C RotorTech® 640mm Wide Cord Blades
CN2342 AeroTech 620mm Wide Cord Wood Blades
CN2343 AeroTech 640mm Wide Cord Wood Blades
No.
1
CNM4X30CS
2
3
4
If you have the HD head, the main blade screw and bolt are going
to be M5 parts.
Congratulations on finishing the build of the Radikal G20 helicopter.
Please follow your instruction manual on setting up your transmit-
ter and gyro systems. Also it is very important that you follow the
instructions included with the Zenoah G20 engine for the break in
process and finally tuning the engine. If the steps are not followed
your engine will not perform at it's optimal levels.
Page 42
3
Part #
CNM4x30CS Cap Screw(杯头内六角螺丝)M4x30
M4 Locknut(M4 螺母)
CNM4LOCK
NOT INCLUDED Rotorblades( 螺旋桨)
HI6139
Gas Fuel Line(油管)
Radikal Gasser
INCLUDED
Description Qty
2
2
2
1