Attaching Head And Main Gear - Century Radikal G20 Instruction Manual

ATTACHING HEAD AND MAIN GEAR

CNM4x4SS
CNM2.5x8CS
10x18x1
Ø3x23.7
CNBB1018T
3
4
Apply grease to the thrust bearing. Place the Main Gear assembly into
the frames. Insert the main shaft with head assembly through the bear-
ing blocks while lining up the thrust bearing, and mast stopper while go-
ing through the Main Gear assembly. Line up the whole in the Main Shaft
with the hole on the Driven Tail Hub. With the help of needle nose pliers
or hemostats, place the Pin (#5) through while making sure you have it
going through the Main Shaft. Install the 2 M4x4 set screws making
sure you have them evenly threaded on both sides. When installing the
Mast Stopper (#3), make sure it is pushed up to the top prior to tighten-
ing the M2.5x8 Cap Screw.
No. Material No.
1 CNBB1018T
Thrust Bearing( 止推轴承)10x18x5.5
CNM2.5X8CS Cap Screw(杯头内六角螺丝)M2.5x8
2
3 HW6054
Mast Stopper( 主轴限位块)
4
CNM4x4SS Set Screw(无头内六角螺丝)M4x4
5 HW6057AS Pin( 插销)Ø3x23.7
6 Copper Washer( 铜垫片)10x18x1
HW6057DS
Page 31
Radikal Gasser
BAG 3
1
2
6
5
4
Description Qty
1
1
1
2
1
1