Main Gear Assembly - Century Radikal G20 Instruction Manual

MAIN GEAR ASSEMBLY

BAG 3
4
5
For the roller bearings, we recom-
mend a very light oil. The oil MUST-
NOT attack/break down plastic as
this could damage the cage in the
one-way bearing. Prior to applying oil,
make sure to clean the roller bear-
7
ings with a cotton swab making sure
there is no debris in the bearings.
3
Be sure to clean the inside and outside of the main shaft
sleeve with alcohol prior to installation.
6
No.
Part #
HW6057A
1
HI6057
2
CNM3x6FHCS
3
4 HW6057C
CNM3x8FHCS
5
HI6057C
6
HW6057D
7
Page 30
Radikal Gasser
Apply medium threadlock to the four
M3x6 flush head cap screws and install
through the tail drive gear tightening
onto the driven tail hub. Apply medium
threadlock to the six M3x8 flush head
cap screws and install onto the main
gear with the auto-rotation one way
1
bearing. Make sure the flush head cap
screws are installed onto the concave
beveled side of the screw holes on the
main gear.
2
CNM3x6FHCS
CNM3x8FHCS
Description
Driven Tail Hub( 传动主齿轮座 )
Tail Drive Gear(传动主齿轮)
Flush Head Cap Screws( 斜头内六角螺丝)M3x6
Main Shaft Sleeve(主齿轮铁套 )
Flush Head Cap Screws( 斜头内六角螺丝)M3x8
Main Gear 90T
(斜齿轮)
One-way Bearing( 单向轴承座)
Qty
1
1
4
1
6
1
1