Makita 9564PC Technical Information page 8

W
iring diagram
( Left side of Motor housing)
Fig. D-2
Fix Controller's Lead wire (black) and that of (blue or white) with the Lead wire holder of Controller,
putting them under Field lead wire ( black) and that of (red).
Controller's lead
wire (black);
to Switch terminal 1
Controller's lead
wire (blue or white);
to Switch terminal 2
Lead wire holder
of Controller
c) Field lead
wire (black)
b) Field lead
wire (red)
b) Fix Field lead wire (red) with
Lead wire holders C and D.
c) Fix Field lead wire (black) with
Lead wire holder D.
And connect to Brush holder.
Lead wire
holder D
Lead wire
Pin
holder C
Pass the following Lead wires
between Pin and Lead wire holder B.
* Field lead wire (red)
* Controller's lead wire (black)
* Controller's lead wire (blue or white)
Controller's Lead wire (red)
to Receptacle/Tab of Field
lead wire (red)
Controller
a) Controller's lead
Pre-set dial
wire (red)
Controller
Lead wire
holder B
a) Fix Controller's lead wire (red) with
Lead wire holders A and B.
P 8 / 10
Lead wire holder of
Motor housing
*(without Pre-set dial:
9564PC , 9565PC,
9566PC)
Receptacle/Tab
Lead wire
holder A